Contact
Linking MES to CAQ
- Benefits:
- No double order registrations
- Never forget an exam again
- Avoid unnecessary inspections
- Machine stop in the absence of an inspection
- Proof of compliance with the regulations
The linking of SK-go!® to your CAQ system ensures that SPC inspections are only initiated when they are actually due. Up to now, fixed inspection intervals were prescribed, now the inspection period is only dependent on the actual running time of the machine recorded in MES or rather on the number of the parts produced. The data exchange of MES with your CAQ system via interface provides decisive advantages:
- Job start in MES also starts the inspection order in CAQ
- At his machine terminal, the operator is requested to perform each due SPC inspection including the first piece inspection.
- If desired, the machine can be stopped in the event of delayed inspection and in case of NOK measurements
- Then the release of the machine only takes place after further inspection of the goods.
- Additional inspections are initiated after certain stop reasons (e.g. tool change) and after a period of machine downtime.
SK-go!® documents the machine running times and inspection points together. In case of critical queries, e.g. as part of audits, you can immediately prove that the test specifications have been consistently observed.
The MES software SK-go!® offers field-tested interfaces for many leading CAQ systems such as Babtec or Böhme & Weihs.
